Plan the sequence from molded part to finished part
Include finishing requirements in the tooling brief before appearance, assembly, and inspection decisions are fixed.
A finished-part requirement can involve several stages after molding, such as preparation, decoration, revêtement, marking, or assembly. The enquiry should explain the desired result and identify the sequence being considered. This helps separate requirements for the molded substrate from requirements for later operations, with responsibilities and acceptance criteria assigned to each stage.
Discutez de Votre ProjetIdentify the base material and the surfaces that will be treated. Mark visible areas, edges, holes, and recesses that may need special attention. Include restrictions on release agents, cleaning, or handling when specified by the finishing process owner.
Describe the proposed finishing steps and who will perform them. Clarify any masking, fixturing, marking, or protected contact areas. Account for the effect of the specified finish on mating features and dimensions rather than evaluating only the untreated part.
Define the condition in which samples must be reviewed: molded, prepared, treated, or fully assembled. Supply appearance references and any required functional checks. Agree how defects, finish variation, damage from handling, and dimensional results will be documented before release.
Les méthodes de finition et leur adéquation doivent être confirmées pour le substrat spécifique et l'application. La proposition de projet doit indiquer quelles opérations sont incluses, qui les réalise, et quelles preuves seront fournies; cette catégorie n'établit pas une liste de processus internes.
Définir la fonction de surface requise, apparence, et la spécification de finition.
Clarifier si l'exigence concerne les pièces plaquées ou les surfaces de moule traitées.
Aligner l'examen des échantillons avec l'état du composant fini.
